How it works
Get in the shower and select your desired water temperature on a small screen. Once you press start, water begins to flow just like in a normal shower, the difference is that instead of the water being wasted by letting it go down the drain, it's collected and pumped though several filters:
- Screen filter (like in a kitchen sink)
To remove hair and large objects and to protect the pump. A gravity filter can also be utilised here
To keep in the filtrate materials but also works like the mesh filter
To filter out particles
- Activated carbon
To clarify the water, remove colour, smell and chemicals
- Ultraviolet light
To sterilise the water from potentially harmful bacteria
COLLECT, CLEAN, STERILISE, REUSE
After passing through the filters the water is clear, clean and bacteria free and ready to be pumped back into the shower head. A small electrical resistor can be used to reheat the water to your set temperature. When you are done the water goes down the drain like normal or you can use the water for something else, like doing your laundry or flushing the toilet to save even more water.
THE ONLY CHALLENGE:
The water needs to be collected for the pump which needs to be placed at the lowest point of the shower, ideally under the basin. If you have an Italian-style shower you can build a new basin instead of tearing the floor apart. We are also working on a way to hack your existing drain and using self-priming pumps so that you can plug the drain during loop mode and suck the water out of the small collection basin.
Connecting the DRAIN
Shower waste trap like in this video or the picture below. I haven't used this product myself but the look is pretty good. It could be more shallow still.
The good thing about this is that it has a thread that you can attach a 1" female to 1/2" male hose connector. Maybe with a 3/4" inch adaptor in between. It's also possible to use PVC pipes with a bigger drain and with space for a dirt lock. Making sure that the screen filter on this drain is very important because it will capture 90% of the largest particles like hair and with a fine mesh skin cells as well. Leaving only tiny things and dissolved solids and liquids to enter the filter.
how it will work
Automate, Monitor, Re-program, Customise
Multiple sensors and a micro-controller are used to allow for complete monitoring and control of the system so you can understand more about your own behavior and personalize the shower to fit your needs (e.g. tell you when to get out of the shower in case you’re in a hurry). You can set your ideal showering conditions like flow rate, water temperature, ambiance and to automatically wash the filters once you've left the shower so that the filters last longer before requiring manual maintenance. By measuring use and changes in flow rate it can inform you when to change filters.
Currently we are using a simple two-row, two-color LCD screen (below) but in the future the interface could look more like this and be programmed by your smart phone (it's just a draft so don't get caught up on the numbers - it's only an example).
Two different setups for the filter. One the left is the POC21 model (see the DIY instructions) made with copper pipes and without the automated control system and slightly smaller filters for a lower flow rate. On the right is the fully operational prototype shower built for 10 l/min and automated piping. Instead of copper pipe, drinking water hose was used. This was used for testing and fast iterations. The image on the left more closely resembles the final product but the placement and look of the filters can be modified by the user.